Cutting test, cross section, microsection image analysis, blowholes

The surface microscope Roboscope can find 10µ small errors in large sections. Typical defects are caused by bubbles, sink marks or cavities. The search is done automatically using industrial image processing

# 1 Blowholes in plastic panels

Sink marks or, as seen here, the formation of bubbles in the plastic material can be examined (dark areas). The sample is lilluminated with a combination of incident and side light

# 2 Rated with image recognition

The area of each bubble is calculated and a consecutive number is assigned. Low number = large area. Resolution 3.5 µm

# 3 Cutout of the previous picture

In the pop up window, data for bubble no. 3, its position and area are shown. In the lower right corner: measurement line 1mm

# 4 Zoom in

Size in mm. High accuracy of the measurement

Any questions? Would you like a demonstration of the practical application based on your product sample? Our team looks forward to your mail

Impressum

Robomat GmbH

Sägewerkstr. 3

83395 Freilassing

Deutschland

Tel +49 8654 4804960

info@Robomat.eu

Geschäftsführer

Dipl. Ing. Dieter Ainedter

UID DE208714801

Handelsregister Traunstein HRB 6508