Measuring microscope, Measurescope for parts up to 147x245mm

Testing machine for measuring flat parts. Were the parts manufactured without errors? Testing with incident and transmitted light is possible. For applications using incident light only, the measuring range is even larger and extends to part dimensions of DIN A4 (210x297mm), or for several small parts at the same time. Measuring range DIN A4 without table movement! No manual alignment of parts is necessary. Highly suitable for manufacturing in mechanical engineering!

# 1 picture sheet metal

The measurements are free of distortion over the entire measuring range . Reliable measuring accuracy of 0.05mm and object-dependent up to 0.02mm

# 2 magnification

Shiny parts can also be measured

# 3 part with 182x110mm

Check whether the machining was done according to the dimensions in the drawing. Due to the large image area for the entire measurement, no table movement or realignment of the sample is necessary. The Dimensioning can be done automatically or manually.

# 4 Technical drawing of the sample
# 5 Top right section, defects detected

Dimensions automatically generated by the image recognition. The test showed that the parts was not ok. The two small holes in the middle have 2.7 instead of 3mm diameter

# 6 Measurement of very small parts, gear wheel of a clock

2.35mm pitch circle 80µm tooth width.

Any questions? Would you like a demonstration of the practical application based on your product sample? Our team looks forward to your mail


Robomat GmbH

Sägewerkstr. 3

83395 Freilassing


Tel +49 8654 4804960


Dipl. Ing. Dieter Ainedter

UID DE208714801

Handelsregister Traunstein HRB 6508